Q- Can we affix the crescent leg to the crescent table? 

A- No, the crescent legs cannot be affixed to the crescent table, you can use a rubber mallet to gently push and secure them in. 

 Q- How do I remove water stains from a marble crescent table?  

A- They can try the steps under Etch removal: 

1. Spritz the surface with fresh water and apply a marble polishing powder [These powders are readily available from your local hardware store]  

1. Rub the powder onto the stone with a damp cloth or by using a buffing pad. Continue buffing until the etch mark disappears and the marble surface shines. 

If they're not confident in doing so we recommend they contact a professional marble restorer/refinisher in their area. 

Q- Is the marble on the Eto and the Crescent the same? 

A- Yes, the marbles on both tables are from the same place - one supplier for Carrara and one supplier for the Nero Marquina. 

Q- What are the overall dimensions of the crescent coffee table?  

A-  

Open

Q- What is the weight of the 1050 – 330H Crescent table in timber?  

A- The table is 30kg 

SPECIFICATIONS

Q- How do you assemble the Crescent Table?  

A-  Step 1: Turn the table top upside down over carpet (or rug/towel etc) to protect the top surface. 

Step 2: Insert the legs by sliding into the receiver under the table top. 

Step 3: If the leg does not insert fully, turn table top on its side and push the leg in fully. 

Complete inserting all legs. 

Step 4: Turn table upright - assembly completed. 

Q- How are the legs secured to the crescent table?  

A- The legs slide in, and you can use a rubber mallet to gently push and secure them in.